Common Disease Problems
Botrytis (Gray Mold): This fungus causes a grey mold on flowers, leaves, stems and buds. It thrives in cool wet weather conditions. Burpee Recommends: Remove affected plant parts, avoid watering at night and getting water on the plant when watering. Make sure plants have good air circulation. Contact your Cooperative Extension Service for fungicide recommendations.
Damping Off: This is one of the most common problems when starting plants from seed. The seedling emerges and appears healthy; then it suddenly wilts and dies for no obvious reason. Damping off is caused by a fungus that is active when there is abundant moisture and soils and air temperatures are above 68 degrees F. Typically, this indicates that the soil is too wet or contains high amounts of nitrogen fertilizer. Burpee Recommends: Keep seedlings moist but do not overwater; avoid over-fertilizing your seedlings; thin out seedlings to avoid overcrowding; make sure the plants are getting good air circulation.
Powdery Mildew: This fungus disease occurs on the top of the leaves in humid weather conditions. The leaves appear to have a whitish or greyish surface and may curl. Burpee Recommends: Avoid powdery mildew by providing good air circulation for the plants by good spacing and pruning. Contact your Cooperative Extension Service for fungicide recommendations.
Common Pest and Cultural Problems
Aphids: Greenish, red, black or peach colored sucking insects can spread disease as they feed on the undersides of leaves. They leave a sticky residue on foliage that attracts ants. Burpee Recommends: Introduce or attract natural predators into your garden such as lady beetles and wasps who feed on aphids. You can also wash them off with a strong spray, or use an insecticidal soap.
Slugs: These pests leave large holes in the foliage or eat leaves entirely. They leave a slime trail, feed at night and are mostly a problem in damp weather. Burpee Recommends: Hand pick, at night if possible. You can try attracting the slugs to traps either using cornmeal or beer. For a beer trap, dig a hole in the ground and place a large cup or bowl into the hole; use something that has steep sides so that the slugs can’t crawl back out when they’re finished. Fill the bowl about ¾ of the way full with beer, and let it sit overnight. In the morning, the bowl should be full of drowned slugs that can be dumped out for the birds to eat. For a cornmeal trap, put a tablespoon or two of cornmeal in a jar and put it on its side near the plants. Slugs are attracted to the scent but they cannot digest it and it will kill them. You can also try placing a barrier around your plants of diatomaceous earth or even coffee grounds. They cannot crawl over these.
Thrips: Thrips are tiny needle-thin insects that are black or straw colored. They suck the juices of plants and attack flower petals, leaves and stems. The plant will have a stippling, discolored flecking or silvering of the leaf surface. Thrips can spread many diseases from plant to plant. Burpee Recommends: Many thrips may be repelled by sheets of aluminum foil spread between rows of plants. Remove weeds from the bed and remove debris from the bed after frost. Check with your Cooperative Extension Service for pest controls.
Ammi majus FAQs
Should I deadhead my Ammi majus? Yes keeping the plant dead headed will extend the bloom time.
Can I indoor sow Ammi majus? We recommend direct sowing because the plant is difficult to transplant.
Does Ammi majus make a good cut flower? Yes its delicate look makes it an excellent filler flower, and it can last 3-10 days as a cut flower. Wear gloves when working with Ammi majus as some people can get a rash from its sap.
Can Ammi majus be used as a dried flower? Yes, hang flowers upside down to dry. Make sure it is dried in a dark place or the white flowers may turn brown.
Can I grow Ammi majus in a container? We do not recommend this, the plant grows 4 feet tall.